He had two SATA burners so I tried the other burner. It just sat there for over two hours and never burned a thing to the DVD. I put the Dell hard disk back into the Dell box, loaded the Acronis TrueImage program and attempted to create a new hard disk image using the Dell's SATA DVD drive. I thought this might be a Norton Ghost problem so I decided to create a new image using Acronis TrueImage 10. I then removed the Dell hard disk, connected it to my shop computer as I did back when I originally made that image and the restore of the image went well. I took the Dell back to my shop again and attempted the restore again and it failed again as I expected. It said there was no image on the disk to restore. The CD would boot to the Ghost restore program but, it would not read the stored image.
![seagate support tools seagate support tools](https://www.hdd-tool.com/pic/Seagate-hard-drive-tools.png)
I recently attempted to restore this image using his SATA CD drive as the boot-and-restore drive. Some months ago, I made a Norton Ghost 2003 image of the Dell hard disk by removing it from the Dell and connecting it to my shop computer. CD drives are inexpensive and generally the newer ones do a much better job of reading home-burned CDs.Īs a side note, I recently ran into an odd situation with a Dell E520 system running SATA exclusively (no PATA support present on the board).
#Seagate support tools upgrade#
This tends to produce more distinct differences between the ones and zeroes.įinally, you can upgrade the computer with a newer CD drive. Most CD burners have the option to write at 4X instead of their normal, higher, speed. Sometimes you can make a disk readable by slowing down the write speed. (Of course you can't re-use the CD and you have to write all the information at once, but re-use is usually less of consideration in a disk you're passing on to someone.) CD-R disks have more contrast than CD-RWs and only cost about half as much. If you burned the CD on a rewritable disk, try putting the information on a read-only (CD-R) disk. The fixes involve doing things differently when you burn CDs. CDs made on a computer don't have as much contrast as commercially made CDs, and some CD players, especially older ones, have trouble with them.įortunately, it's usually possible to work around the problem.
![seagate support tools seagate support tools](https://www.seagate.com/files/www-content/product-content/_archive/compactflash-photo-fam/_shared/images/Seagate-CFdrive8GB-compact-flash-photo-270x270.png)
Unlike commercial CDs, where bits are pits are pressed into the disk to represent information, CD burners in home computers rely on using a laser to produce different colored spots to represent the same information. Have you ever burned a CD for a friend, but it won't play on their computer? It plays fine on your system, but the other computer acts like there's nothing on the CD.ĬD drives differ considerably in their ability to read homemade CDs. Contrast can sometimes be increased by burning at a slower speed however, sometimes the only solution is to replace the drive with a more modern one. The drive reads factory disks but not CD/DVD-Rsġ) Factory CDs have more contrast between the ones and zeros than CD-Rs.